All types

Standard Transmission and Gear at 1000 Northeast 29th Street in Fort Worth, Texas

Standard Transmission and Gear in 1000 Northeast 29th Street, Texas: consumer reviews, opening hours, driving directions, photos etc.

Map is loading...

Categories: Car repair

Address:

1000 Northeast 29th Street,
Fort Worth, Texas
76106
Get directions

Phone: +1 817-625-7109

Web site: standardtransmission.com

Opening hours Closed now

Tomorrow: 07:30 am — 05:30 pm

Monday
07:30 am — 05:30 pm
Tuesday
07:30 am — 05:30 pm
Wednesday
07:30 am — 05:30 pm
Thursday
07:30 am — 05:30 pm
Friday
07:30 am — 05:30 pm

Reviews about Standard Transmission and Gear

  • ✪ ✪ ✪ ✪
    Where do i begin with this place, the first time i sent my nv3500 manual transmission to them i had it back in a timely manner. After it was installed i noticed it was leaking, leaking from a crack in the side of the case that wasn't there when i sent it in. So i sent it back to them, almost three weeks later i got it back. A couple months later bearings started going out internally making a God awful noise and now i am outside the six month warranty. So back to the transmission shop it went. Got it back and it is still noisy, doesn't shift very smooth, fyi, has a new clutch, slave/master cylinder, & fly wheel, and has started leaking again. Keep in mind i think i have put about 12k total miles on it since i put it back in this last time. On the plus side though, they didnt give me any problems warranting the problems. It is just a pain to pull the tranny because of it being 4wd. Having done it three times i can have it all out in a little over an hour. I also have a co-worker that got a ford manual tranny from them and it went back out in 60k miles.
    by Matthew robberson
    November 14, 2017
  • First off, let me give a thanks to Sabien and the rest of the staff at Standard Gear and Transmission! The service was awesome, and the results are incredible! Hopefully my experience will help others with the Cummins / G56 drivetrain. My throwout bearing was making noise for some time, and I continued to drive the truck, as it is my daily driver. Long story short, this destroyed my clutch fork, input shaft, and input bearing. I was on the fence for some time about doing away with the stock dual-mass flywheel and clutch. Sabien recommended a South Bend Clutch OFEK kit, and let me say, it is amazing! The engagement is similar to stock, but very positive. It does not grab, and shifts are silky smooth. The trans was refilled with 30 wt synchromesh, and it now runs smoother and quieter than I ever believed a G56 could. Pedal effort with the new hydraulics is so light that I nearly pushed the pedal through the floorboard when I started the truck for the first time. Gone are the truck's tendency to buck and jerk in reverse, and the noises from the factory clutch. I'm literally having to learn to drive the truck again, as it's manners and sounds are like new. I would HIGHLY recommend this clutch! Thanks again to Standard Trans. And Gear!
    by Josh H.
    July 12, 2017
How would you rate this service?

Photo gallery of Standard Transmission and Gear

About Standard Transmission and Gear in Fort Worth

Standard Transmission and Gear is located at 1000 Northeast 29th Street, Fort Worth, Texas.